IB IL 24 DO 8-2MBD-PAC - Digital module

2861687

Inline, Digital output terminal, Digital outputs: 8, 24 V DC, connection technology: 4-conductor, transmission speed in the local bus: 2 Mbps, degree of protection: IP20, including Inline connectors and marking fields

The terminal is designed for use within an Inline station. It is used to output digital signals.

Width 48.8 mm
Height 119.5 mm
Depth 71.5 mm
Note on dimensions Housing dimensions

Inline local bus
Number of interfaces 2
Connection method Inline data jumper
Transmission speed 2 Mbps

Module
ID code (dec.) 189
ID code (hex) BD
Length code (hex) 81
Length code (dec) 129
Process data channel 8 bit
Input address area 0 Byte
Output address area 1 Byte
Register length 8 bit
Required parameter data 3 Byte
Required configuration data 4 Byte

Digital:
Output name Digital outputs
Connection method Spring-cage connection
Connection technology 4-conductor
Number of outputs 8
Protective circuit Overload protection, short-circuit protection of outputs
Output voltage 24 V DC (US - 1 V)
Maximum output current per channel 500 mA
Maximum output current per module 4 A
Nominal output voltage 24 V DC (voltage difference at Inom ≤ 1 V)
Nominal load, inductive 12 W
Nominal load, lamp 12 W
Nominal load, ohmic 12 W
Behavior with overload Auto restart
Behavior with inductive overload Output can be destroyed
Behavior at voltage switch-off The output follows the power supply without delay

Product type I/O component
Product family Inline
Type modular
Scope of delivery including Inline connectors and marking fields
Operating mode Process data mode with one byte
Diagnostics messages Short-circuit or overload of the digital outputs Error message in the diagnostic code (bus) and display (2 Hz) via the LED (D) on the module
Insulation characteristics
Overvoltage category II (IEC 60664-1, EN 60664-1)
Pollution degree 2 (IEC 60664-1, EN 60664-1)

Potentials: Communications power (UL)
Supply voltage 7.5 V DC (via voltage jumper)
Current draw max. 85 mA
Power consumption 0.64 W
Potentials: Segment circuit supply (US)
Supply voltage 24 V DC (via voltage jumper)
Supply voltage range 19.2 V DC ... 30 V DC (including all tolerances, including ripple)
Current draw max. 4 A
Electrical isolation/isolation of the voltage ranges
Test voltage: 5 V supply, incoming remote bus/7.5 V supply (bus logics) 500 V AC, 50 Hz, 1 min.
Test voltage: 5 V supply, outgoing remote bus/7.5 V supply (bus logics) 500 V AC, 50 Hz, 1 min.
Test voltage: 7.5 V supply (bus logics)/24 V supply (I/O) 500 V AC, 50 Hz, 1 min.
Test voltage: 24 V supply (I/O) / functional ground 500 V AC, 50 Hz, 1 min.

Connection technology
Connection name Inline connector