REL-MR- 24DC/ 1ICT - Single relay

2987338

Pluggable miniature power relay, with tungsten pre-contact for high switch-on currents up to 800 A peaks, 1 N/O contact, input voltage: 24 V DC

Product type Single relay
Operating mode 100% operating factor
Mechanical service life 3x 107 cycles
Insulation characteristics
Insulation Safe isolation, reinforced insulation
Insulation characteristics
Insulation Safe isolation, reinforced insulation
Overvoltage category III
Pollution degree 3

Maximum power dissipation for nominal condition 0.41 W
Test voltage (Winding/contact) 5 kV AC (50 Hz, 1 min., winding/contact)
Rated insulation voltage 250 V AC
Rated surge voltage 6 kV

Coil side
Nominal input voltage UN 24 V DC
Input voltage range 19.2 V DC ... 54 V DC
Input voltage range in reference to UN see diagram
Drive and function monostable
Drive (polarity) non-polarized
Typical input current at UN 17 mA
Typical response time 8 ms
Typical release time 3 ms
Coil resistance 1440 Ω ±10 % (20 °C)

Switching
Contact switching type 1 N/O contact
Type of switch contact Single contact
Contact material AgSnO
Maximum switching voltage 250 V AC/DC
Minimum switching voltage 12 V (100 mA)
Limiting continuous current 16 A
Maximum inrush current 165 A (20 ms)
800 A (200 µs)
Min. switching current 100 mA (at 12 V DC)
Interrupting rating (ohmic load) max. 384 W (at 24 V DC)
58 W (at 48 V DC)
48 W (at 60 V DC)
50 W (at 110 V DC)
80 W (at 220 V DC)
4000 VA (for 250 V AC)
Switching capacity min. 1200 mW
Switching capacity 2 A (at 24 V, DC13)
0.2 A (at 110 V, DC13)
0.2 A (at 250 V, DC13)
6 A (at 24 V, AC15)
6 A (at 120 V, AC15)
6 A (at 250 V, AC15)

Connection method Plug / solder connection

Dimensional drawing
Width 12.7 mm
Height 29 mm
Depth 15.7 mm

Color white (RAL 9010)

Ambient conditions
Degree of protection RT II
Ambient temperature (operation) -40 °C ... 85 °C
Ambient temperature (storage/transport) -40 °C ... 85 °C
Altitude ≤ 2000 m

Corrosive gas test
Identification ISA-S71.04. G3 Harsh Group
EN 60068-2-60