RIF-2-RSC-LV-230AC/2X21 - Relay Module
2903321
Preassembled relay module with screw connection, consisting of: relay base, power contact relay, plug-in display/interference suppression module, and retaining bracket. Contact switching type: 2 changeover contacts. Input voltage: 230 V AC
Product type Relay Module
Product family RIFLINE complete
Application Universal
Operating mode 100% operating factor
Mechanical service life approx. 2x 107 cycles
Insulation characteristics
Insulation Basic insulation
Insulation characteristics
Insulation Basic insulation
Overvoltage category III
Pollution degree 2 (Rated voltage of 230/400 V)
Maximum power dissipation for nominal condition 1.5 W
Test voltage (Winding/contact) 2.5 kVrms (50 Hz, 1 min., winding/contact)
Test voltage (Contact/contact) 2.5 kVrms (50 Hz, 1 min., contact/contact)
Rated insulation voltage 250 V AC
Rated surge voltage 4 kV
Coil side
Nominal input voltage UN 230 V AC
Input voltage range 184 V AC ... 276 V AC (20 °C)
Input voltage range in reference to UN see diagram
Mains frequency 50/60 Hz
Drive and function monostable
Drive (polarity) polarized
Typical input current at UN 6.5 mA
Typical response time 5 ms ... 15 ms
Typical release time range 5 ms ... 20 ms
Coil voltage 230 V AC
Protective circuit Varistor
Operating voltage display Yellow LED
Switching
Contact switching type 2 changeover contacts
Type of switch contact Single contact
Contact material AgNi
Maximum switching voltage 250 V AC/DC
Minimum switching voltage 5 V (24 mA)
Limiting continuous current 8.5 A (see diagram)
Maximum inrush current 30 A (20 ms, N/O contacts)
Min. switching current 5 mA (24 V)
Interrupting rating (ohmic load) max. 204 W (24 V DC)
124 W (48 V DC)
108 W (60 V DC)
52 W (110 V DC)
48 W (220 V DC)
2125 VA (250 V AC)
Utilization category CB Scheme (IEC 60947-5-1) AC15, 1.5 A/240 V (N/O contact)
DC13, 2 A/24 V (N/O contact)
Connection method Screw connection
Stripping length 8 mm
Conductor cross section rigid 0.5 mm² ... 4 mm²
Conductor cross-section rigid (2 conductors with same cross section) 0.5 mm² ... 2.5 mm²
Conductor cross section flexible 0.5 mm² ... 4 mm²
0.5 mm² ... 4 mm² (Ferrule with plastic sleeve)
Conductor cross section flexible (2 conductors with same cross section) 0.5 mm² ... 2.5 mm²
0.5 mm² ... 1.5 mm² (TWIN ferrule with plastic sleeve)
Conductor cross section AWG 20 ... 10 (solid)
20 ... 12 (flexible)
Tightening torque 0.5 Nm ... 0.6 Nm
