SACC-M12MS-8CON-PG 9-SH - Connector
1511857
Connector, Universal, 8-position, shielded, Plug straight M12, coding: A, Screw connection, knurl material: Brass, nickel-plated, external cable diameter 6 mm ... 8 mm
Assembly instruction: NOTE: Observe the permissible bending radii when laying conductors, since the degree of protection may be put in jeopardy if the bending forces are too high. Alleviate mechanical loads upstream of the connector, e.g. by using cable ties.
Product type Circular connector (cable-side)
Sensor type Universal
Number of positions 8
No. of cable outlets 1
Shielded yes
Coding A
Insulation characteristics
Overvoltage category II
Degree of pollution 3
Dimensional drawing
Width 20 mm
Height 20 mm
Length 62 mm
Wrench size, union nut 18 mm
Wrench size, counter nut 17 mm
External dimensions
Outside diameter 6 mm ... 8 mm
Housing
Diameter housing 20 mm
Flammability rating according to UL 94 HB
Seal material Silicon
Material of grip body Brass, nickel-plated
Contact material CuZn
Contact surface material Au
Contact carrier material PA
Material for screw connection Brass, nickel-plated
Conductor connection
Connection method Screw connection
Connection cross section 0.25 mm² ... 0.5 mm² (without ferrule)
0.14 mm² ... 0.34 mm² (with ferrule)
0.25 mm² ... 0.5 mm² (solid)
Connection cross section AWG 24 ... 20 (without ferrule)
26 ... 22 (with ferrule)
Stripping length of the individual wire 5 mm
Tightening torque 0.4 Nm (M12 knurl)
0.2 Nm (Screw terminal blocks)
1 Nm (Pressure nut with coupling sleeve)
Rated surge voltage 0.8 kV
Contact resistance ≤ 8 mΩ
Insulation resistance ≥ 100 MΩ
Nominal voltage UN 30 V AC
30 V DC
Nominal current IN 2 A
Mechanical data
Insertion/withdrawal cycles ≥ 100
Connection 1
Head design Plug
Head cable outlet straight
Head thread type M12
Coding A
Signal type/category Universal
Stripping length of the individual wire 5 mm
Ambient conditions
Degree of protection IP67
Ambient temperature (operation) -40 °C ... 85 °C (Plug / socket)
Standard designation M12 connector
Standards/specifications IEC 61076-2-101